We offer an assortment of stainless steel flanges that are widely used in many industries. Our SS flanges are available in different technical specifications which conform to.Various grades of SS flanges that we trade are as follows.

Standard: ASTM / ASME A/SA 182

Grade: F 304, 304L, 304H, 309S, 309H, 310S, 310H, 316, 316TI, 316H, 316L, 316LN, 317, 317L, 321, 321H, 347, 347H, 904L.

Our wide array of nickel steel flanges finds wide application in varied industries and is acknowledged for their consistence performance and durability. Our range of nickel alloy flanges conform to.We offer our clients’ superior nickel alloy flanges and the grades that we offer includes.

Standard: ASTM / ASME SB 564 / 160 / 472

Grade: UNS 2200 (NICKEL 200), UNS 4400 (MONEL 400), UNS 8825 INCONEL (825), UNS 6600 (INCONEL 600), UNS 6601 (INCONEL 601), UNS 6625 (INCONEL 625), UNS 10276 (HASTELLOY C 276), UNS 2201 (NICKEL 201), (ALLOY 20 / 20 CB 3).

We procure wide range of qualitative carbon steel and alloy steel flanges from verified vendors spread all over the globe. For carbon steel flanges we conform to standards and for alloy steel flanges we adapt.Various grades of carbon steel & alloy steel flanges that we offer our clients’ are.

Standard: ASTM / ASME A/SA 105 / 350 LF 2

Standard: ASTM / ASME A/SA 182

Grade: F5, F9, F11, F12, F22, F91.

This flange is circumferentially welded into the system at its neck which means that the integrity of the butt welded area can be easily examined by radiography. The bores of both pipe and flange match, which reduces turbulence and erosion inside the pipeline. The weld neck is therefore favoured in critical applications

his flange is slipped over the pipe and then fillet welded. Slip-on flanges are easy to use in fabricated applications

This flange is used to blank off pipelines, valves and pumps, it can also be used as an inspection cover. It is sometimes referred to as a blanking flange.

These flanges are always used with either a stub end or taft which is butt welded to the pipe with the flange loose behind it. This means the stub end or taft always makes the face. The lap joint is favoured in low pressure applications because it is easily assembled and aligned. To reduce cost these flanges can be supplied without a hub and/or in treated, coated carbon steel.

This flange is referred to as either threaded or screwed. It is used to connect other threaded components in low pressure, non-critical applications. No welding is required.

This flange is counter bored to accept the pipe before being fillet welded. The bore of the pipe and flange are both the same therefore giving good flow characteristics.